Delphi - How to re-enable a debugger exception notification?

Question

I opened a project (created in D2007/08) in D2009 and it would compile but throw tons of exceptions when executed. Strange thing, but I know the project's a mess, so I want to go ahead and fix it. Well, not really fix all of it, just make it work would be enough.

When I ran it, I got some Debugger Exception Notification (the little message dialogue with Break, Continue, Help buttons) and I wanted to proceed and see if would perhaps work when skip over the exception. I checked the little "Ignore this exception type" check box in the bottom left corner and clicked Continue. Now I no longer get the Exception Notification, but the application still doesn't run. I just get a couple of vague error boxes and have very little idea what's going on.

I would like to re-enable the exception type I previously selected to be ignored. But I can't find the option anywhere. Where should I look for this? Can anyone help?

Answer 1

I have found the ignored exception types in

(Main menu) Tools >> Options >> Debugger Options >> CodeGear Debuggers >> Language Exceptions >> and there is the list of exception types ignored.

It's somewhat more hidden than in D2005 but very close to what was said in the article referenced by Stuart Dunkeld.

Answer 2

The following is extracted from this page on the Delphi Q&A by Rob Kennedy: (CC licensed) although it relates to Delphi 2005 it may help.

Why do I continue getting error messages even after I have written an exception handler?

In its default settings, the Delphi IDE notifies you whenever an exception occurs in your program, as in Figure 1. What’s important to realize is that at that point, none of your program’s exception-handling code has run yet. It’s all Delphi itself; its special status as a debugger allows it to get first notification of any exception in your program, even before your program knows about it.

Avoiding notification

If you do not want to be notified when an exception occurs, you have a few options.

• You can use Delphi’s “advanced breakpoints” to disable exception handling around a region of code. To begin, set a breakpoint on the line of code where you want the IDE to ignore exceptions. Right-click on the breakpoint dot in the gutter and open the breakpoint-property dialog. In the advanced section are some check boxes. (See Figure 2.) Clear the “Break” box to prevent the debugger from interrupting your program at that line, and set the “Ignore subsequent exceptions” box.

  Afterward, set another breakpoint where you want the debugger to resume handling exceptions. Change its properties to handle subsequent exceptions.

• You can tell the debugger to ignore certain kinds of exceptions. Figure 3 shows Delphi’s language-exception options. Add an exception class to the list, and all exceptions of that type and of any descendant types will pass through to your program without Delphi interfering.

• In an option related to the previous one, you can tell the debugger not to interrupt on any exceptions. To do that, clear the “Notify on language exceptions” check box.

• Finally, you can turn off integrated debugging altogether. Delphi will not notify you of exceptions, and it will also not stop at breakpoints or allow use of the “Pause” button. Turn off integrated debugging in the debugger options, as shown in Figure 5 for Delphi 2005.