For small files:
dd if=/dev/zero of=upload_test bs=file_size count=1
Where file_size
is the size of your test file in bytes.
For big files:
dd if=/dev/zero of=upload_test bs=1M count=size_in_megabytes
Please, modern is easier, and faster. On Linux, (pick one)
truncate -s 10G foo
fallocate -l 5G bar
It needs to be stated that truncate
on a file system supporting sparse files will create a sparse file and fallocate
will not. A sparse file is one where the allocation units that make up the file are not actually allocated until used. The meta-data for the file will however take up some considerable space but likely no where near the actual size of the file. You should consult resources about sparse files for more information as there are advantages and disadvantages to this type of file. A non-sparse file has its blocks (allocation units) allocated ahead of time which means the space is reserved as far as the file system sees it. Also fallocate
nor truncate
will not set the contents of the file to a specified value like dd
, instead the contents of a file allocated with fallocate
or truncate
may be any trash value that existed in the allocated units during creation and this behavior may or may not be desired. The dd
is the slowest because it actually writes the value or chunk of data to the entire file stream as specified with it's command line options.
This behavior could potentially be different - depending on file system used and conformance of that file system to any standard or specification. Therefore it is advised that proper research is done to ensure that the appropriate method is used.
Just to follow up Tom's post, you can use dd to create sparse files as well:
dd if=/dev/zero of=the_file bs=1 count=0 seek=12345
This will create a file with a "hole" in it on most unixes - the data won't actually be written to disk, or take up any space until something other than zero is written into it.
Use this command:
dd if=$INPUT-FILE of=$OUTPUT-FILE bs=$BLOCK-SIZE count=$NUM-BLOCKS
To create a big (empty) file, set $INPUT-FILE=/dev/zero
.
Total size of the file will be $BLOCK-SIZE * $NUM-BLOCKS
.
New file created will be $OUTPUT-FILE
.
If you love us? You can donate to us via Paypal or buy me a coffee so we can maintain and grow! Thank you!
Donate Us With