Wireless communication: AVR based embedded system and iPhone

Question

What is the best way to realize wireless communication between an embedded system (based on an AVR controller) and the iPhone? I think there are only two options: either WiFi or BlueTooth. The range is not really a problem, since both devices should stay in the same room.

I have no idea, if there are any useful WiFi boards that can be connected to an AVR based microcontroller system (or any small microcontroller), any hints would be highly welcome.

I guess the better solution would be BlueTooth, but there is also the problem: which BlueTooth board is best suited for attachment to an AVR system, and is it possible to use the iPhone BlueTooth stack for (serial) communication over BlueTooth with the AVR device.

I hope that somebody already realized such a system and can give some helpful tips...

Answer 1

You can get modules for both WiFi and Bluetooth that will connect to an embedded system through a UART interface, however a WiFi module will have far more processing power than your AVR microcontroller, often with spare capacity and I/O to execute additional user code, so connecting one to an AVR maybe somewhat redundant in many cases.

Bluetooth modules are simpler, less expensive, and the data-rate is better matched to the AVR's capabilities. For example these Parani modules. I have used them between an embedded system and a Laptop PC's Bluetooth, so given appropriate communications software, there is no technical reason why it could not be used with an iPhone I think. However this may be the flaw, on the PC the device was recognised as a virtual serial port, I don't know whether iPhone supports 'legacy' communications in quite the same way.

For comparison, a WiFi solution