What to do when a form's class becomes too large?

Question

Currently my main form has a ton of event handlers because there are a lot of controls. It is very similar to a paint application. I have condensed it down quite a bit and I am sharing event handlers whenever possible but the class is still around 1,000 lines of code. I realize that may not be much to all of you but it is considerably larger than the rest of my classes.

I have refactored a lot of code to other classes but all those event handlers still increase the line count by a large amount. I also started using region blocks to separate event handlers in to groups and that is working rather well but I still would like to know SO's opinion on the matter as to best organize a large amount of form event handlers.

Edit: So I've been using partial classes and I must say, I don't really like them that much. I'm not sure what to do at this point.

I may go back to using region blocks as I'm not sure user controls will help my problem at all. Honestly I did not mind the region blocks that much. That class was the only place I used them and it organized the different sections of the code quite nicely (Menu Event Handlers, Toolstrip Event Handlers, Drag and Drop Support, et cetera).

Still, if anyone still has any other ideas or would like to elaborate upon any posted thus far I'd be more than appreciative as I am still looking for a better solution to this problem.

Answer 1

1000 lines of code is nothing, and that should not be the basis for refactoring your code. Refactor your code where it makes sense; not just because a class contains more lines of code than your other classes. Some classes will require more code than others, and that's perfectly okay.

That being said, if it makes sense you can divide the controls into logical sections, and put them in user controls. Make sure that there is a good justification for doing so though, because otherwise you'll only be convoluding your code base.

I must remind you again though, don't split your code up just to reduce the lines of code.