VAG TP 2.0 complete list of AT commands

Question

I am trying to find DTCs from various ECUs in a Skoda Rapid 2009 model. I am using OBDLink SX (elm 327 chip) and Putty (similar to HyperTerminal)

https://jazdw.net/tp20 This link gives the list of commands that I should request the ECUs of any VAG car because they run on TP 2.0 protocol. But I am unable to get any response. It always gives me 'NO DATA'. I think I am missing 'AT' commands like maybe set timeout or wakeup message.

>at z 
at z 


ELM327 v2.1 



>at h1 
at h1 
OK 

>at l1 
at l1 
OK 

>at s1 
at s1 
OK 

>at pb c001 
at pb c001 
OK 

>at d1 
at d1 
OK 

>at sp b 
at sp b 
OK 

>at sh 200 
at sh 200 
OK 

>05 c0 00 10 00 03 01 1 
05 c0 00 10 00 03 01 1 
205 7 00 D0 00 03 68 07 01 

>03 c0 00 10 00 03 01 1 
03 c0 00 10 00 03 01 1 
203 7 00 D0 00 03 90 07 01 


>at sh 768 
at sh 768 
OK 

>at cra 300 
at cra 300 
OK 

>a0 0f 8a ff 32 ff 
a0 0f 8a ff 32 ff 
NO DATA 

>a0 0f 8a ff 32 ff 1 
a0 0f 8a ff 32 ff 1 
NO DATA 

Can someone help me to list the step by step commands to get VAG DTCs from engine, ABS, Airbag, EPS etc. Online resources will be helpful too.

Answer 1

This looks like you do not have set the right protocol settings (sp / pb) to me. Are you certain about the parameters and/or the right protocol? Which OBD hex commands are you trying to send there?

P.S. this should be a comment but due to a lack of reputation (50) i cannot make one...

UPDATE

If you get

NO DATA

the ELM documentation states:

Not all requests are supported by every vehicle. Yours may not have data to give, or was never designed to respond to this PID (or SID). If you are sure that the vehicle should be responding to this request, then check that the ELM IC’s timeout has not been set too short. Try issuing a AT ST FF command so the chip waits a full second before declaring there is no data available. Maybe your ECU just has higher priority things to attend to, and it is taking longer for it to answer you.

Maybe some ECU is too slow in responding. Try the suggested command for the longer timeout and please report back. Also check the (eventually!) expected output for these ECUs if possible.