Managing Cisco programmatically; Telnet vs SNMP? [closed]

Question

I was recently approached by a network-engineer, co-worker who would like to offload his minor network admin duties to a junior-level helpdesk tech. The specific location in need of management acts as an ISP for tenants on its single-site property, so there's a lot of small adjustments being made on a daily basis.

I am thinking it would be helpful to write him a winform app to manage the 32 Cisco devices, on-site. I'd like to initially provide functionality which could modify access control lists, port VLAN assignments, and bandwidth limitations per VLAN... adding more to the list as its deemed valuable.

My initial thought was to emulate a telnet session with the network device; utilizing my network-engineer's familiarity with the command-line / IOS interaction. Minimal time would be required to learn Cisco IOS conventions, myself.

Though while searching for solutions, it appears that most people favor SNMP. That, or, their specific circumstances pushed them in the direction of SNMP.

I wanted to know if I've overlooked an obvious benefit of SNMP. Should I be using SNMP? Why or why not?

Answer 1

SNMP is great for getting information out of a Cisco device, but is not very useful controlling the device. (although technically, you can push a new config to a Cisco IOS device using a combination of SNMP and TFTP. But sending a whole new config is a pretty blunt instrument for controlling your router or switch).

One of the other commenters mentioned the Cisco IOS XR XML API. It's important to note that the IOS XR XML API is only available on devices that run IOS XR. IOS XR is only used on a few of Cisco's high end carrier class devices, so for 99% of all Cisco routers and switches the IOS XR XML API is not an option.

Other possibilities are SSH or HTTP (many Cisco routers, switches, AP, etc. have an optional web interface). But I'd recommend against either of those. To my knowledge, the web interface isn't very consistent across devices, and a rather surprising number of Cisco devices don't support SSH, or at least don't support it in the base license.

Telnet is really the only way to go, unless you're only targeting a small range of device models. To give you something to compare against, Cisco's own CiscoWorks network management software uses Telnet to connect to managed devices.