Hacking computer hardware to do experiment control

Question

I am a physicist, and I had a revelation a few weeks ago about how I might be able to use my personal computer to get much finer control over laboratory experiments than is typically the case. Before I ran off to try this out though, I wanted to check the feasibility with people who have more expertise than myself in such matters.

The idea is to use the i/o ports---VGA, ethernet, speaker jacks, etc.---on the computer to talk directly to the sensors and actuators in the experimental setup. E.g. cut open one side of an ethernet cable (with the other end attached to the computer) and send each line to a different device. I knew a postdoc who did something very similar using a BeagleBone. He wrote some assembly code that let him sync everything with the internal clock and used the GPIO pins to effectively give him a hybrid signal generator/scope that was completely programmable. It seems like the same thing should be possible with a laptop, and this would have the additional benefit that you can do data analysis from the same device.

The main potential difficulty that I foresee is that the hardware on a BeagleBone is designed with this sort of i/o in mind, whereas I expect the hardware on a laptop will probably be harder to control directly. I know for example (from some preliminary investigation, http://ask.metafilter.com/125812/Simple-USB-control-how-to-blink-an-LED-via-code) that USB ports will be difficult to access this way, and VGA is (according to VGA 15 pin port data read and write using Matlab) impossible. I haven't found anything about using other ports like ethernet or speaker jacks, though.

So the main question is: will this idea be feasible (without investing many months for each new variation of the hardware), and if so what type of i/o (ethernet, speaker jacks, etc.) is likely to be the best bet?

Auxiliary questions are:

1. Where can I find material to learn how I might go about executing this plan? I'm not even sure what keywords to plug in on Google.

2. Will the ease with which I can do this depend strongly on operating system or hardware brand?

Answer 1

The only cable I can think of for a pc that can get close to this would be a parallel printer cable which is pretty much gone away. It's a 25 wire cable that data is spread across so that it can send more data at the same time. I'm just not sure if you can target a specific line or if it's more of a left to right fill as data is sent.

To use one on a laptop today would definitely be difficult. You won't find any laptops with parallel ports. There are usb to parallel cables and serial to parallel cables but I would guess that the only control you would have it to the usb or serial interface and not the parallel.

As for Ethernet, you have 4 twisted pair with only 2 pair in use and 2 pair that are extra.

There's some hardware that available called Zwave that you might want to look into. Zwave will allow you to build a network of devices that communicate in a mesh. I'm not sure what kind of response time you need.

I actually just thought of something that might be a good solution. Check out security equipment. There's a lot of equipment available for pc's that monitor doors, windows, sensors, etc. That industry might what your looking for.