Get BLE Scan without filter duplicate UUID

Question

I'm writing an BLE application, where need to track if peripherals device is advertising or has stop.

I followed getting peripherals without duplications this and BLE Filtering behaviour of startLeScan() and I completely agree over here.

To make it feasible I kept timer which re-scan for peripherals after certain time (3 sec). But with new device available on market(with 5.0 update), some time re-scan take bit time to find peripherals.

Any suggestion or if anyone have achieved this?

Answer 1

Sounds like you're interested in scanning advertisements rather than connecting to devices. This is the "observer" role in Bluetooth Low Evergy, and corresponds to the "broadcaster" role more commonly known as a Beacon. (Bluetooth Core 4.1 Vol 1 Part A Section 6.2)

Typically you enable passive scanning, looking for ADV_IND packets broadcast by beacons. These may or may not contain a UUID. Alternatively, you can active scan by transmitting SCAN_REQ to which you may receive a SCAN_RSP. Many devices use different advertising content in ADV_IND and SCAN_RSP to increase the amount of information that can be broadcast - you could, for instance, fit a UUID128 into the ADV_IND followed by the Device Name in the SCAN_RSP. (Bluetooth Core 4.1 Vol 2 Part E Section 7.8.10)

Now you need to define "go away" - are you expecting the advertisements to stop or to fade away? You will get a Receive Signal Strength Indication "RSSI" with each advertisement (Bluetooth Core 4.1 Vol 2 Part E Section 7.7.65.2) - this is how iBeacon positioning works and there's plenty of support for beacon receivers in Android.

Alternatively you wait for N seconds for an advertisement that should be transmitted every T seconds where N>2T. The downside of the timed approach is that probably not receiving a beacon isn't the same as definitely receiving a weak beacon; to be sure you need N to be large and that impacts the latency between the broadcaster being switched off or moving out of range and your app detecting it.

One more thing - watch out that Advertising stops if something connects to a Peripheral (if you really are scanning for peripherals) another good reason to monitor RSSI.

Answer 2

First scenario: Bonded Devices

We know that if a bond is made, then most of the commercially available devices send directed advertisements in during re-connection. In situations such as this, according to BLE 4.0 specification, you cannot scan these devices on any BLE sniffer.

Second scenario: Connectable Devices

Peripheral devices are usually in this mode when they are initially in the reset phase. The central sends a connect initiator in response to an advertisement packet. This scenario offers you a lot of flexibility since you can play around with two predominant configuration options to alter connection time. These are: slavelatency on the peripheral and conninterval on the central. Now, I don't know how much effort it's going to take get it working on the Android platform, but if you use the Bluez BLE stack and a configurable peripheral such as a TI Sensor tag, then you can play around with these values.

Third scenario: Beacon devices

Since this is what your question revolves around, according to the BLE architecture, there are no parameters to play with. In this scenario, the central is just a dumb device left at the mercy of when a peripheral chooses to send it's beaconing signal.

Reference:

http://www.amazon.com/Inside-Bluetooth-Communications-Sensing-Library/dp/1608075796/ref=pd_bxgy_14_img_z

http://www.amazon.com/Bluetooth-Low-Energy-Developers-Handbook/dp/013288836X/ref=pd_bxgy_14_img_y